Change output level

Use this setting if you want WinMLS to automatically change the output level after a measurement s performed. This is useful when performing automated measurements, e.g. when checking how high output level is needed to exceed a distortion limit.

If the increase check box  is checked as shown above, the level will be set after a measurement is performed.

In the example above, the output level will start at -10 dBFS and will be in increased with 5 dB after each measurement until 0 dBFS is reached.

You may also decrease the output level by typing a negative number as shown below.

In this example, the ouput level will start at -10 dBFS and be decreased with 5 dB after each measurement until -40 dBFS is reached.

Clicking the  button will reset the current level to the initial output level which in this case was -10 dBFS as shown below.