Setting the axis label increment is useful e.g. if you want to plot the magnitude frequency response using axis labels with an increment of 5 dB per division for comparing with printouts from other measurement systems.
You can force WinMLS to
label the selected axis using a specified increment. From
Plot->Layout->Edit....
click on the Axis tab. Select the axis you want to modify (Left
axis or Bottom Axis) in the left corner of the dialog box. Then click
on the Scales tab (see figure below). Click on the button found at the bottom of
the figure below. In the new dialog, type the desired increment using
comma as separator and click OK. If you type “0,2”, the Desired
Increment will be set to 0,2 as shown to the right in the figure
below.
Note that labels at the selected increments will only be displayed if there is enough separation between the labels. This should not be a problem, but by clicking the Labels tab shown in the figure above the separation can be set in percentage: