 |
|
Some general plot-settings are found on the standard toolbar to the right of the Cal button.
Important settings are found on Plot Toolbar (positioned at the bottom in the default setups).
From the Plot Toolbar you can do zooming, choose plot type, choose to display one or two plots in the window and open the settings dialog box for the active plot type.
How to set the plot type (e.g. to waterfall) and determine what measurement is to be plotted?
How to access the settings for the plot type?
How to change the vertical axis scaling?
Why is the phase shift not within 360 degrees when measuring with WinMLS?
How to filter a measurement, e.g. using a bandpass filter?
How to change the color of a waterfall plot?
What toolbars are useful when working with a waterfall plot?
What waterfall calculation mode should be used?
If waterfall is plotted, how to read the value of a specific waterfall slice?
How to set the depth of the waterfall plot?
When plotting waterfall, how to select the start point?
The right part of my waterfall look strange, how can I fix this?
How to set the time data window when plotting in frequency domain?
Where are the plot cursor values (x,y) displayed?
Where is the wavelength displayed?
How to change the wavelength unit from meters to feet?
How to save the curve data in the plot?
How to save the plot as a picture?
How to view and manipulate the data of the plotted curves?
How to make calculations, such as subtraction?
How to plot the level of a measurement in octave or one-third-octave bands?
Why can I not see the (one-third)-octave values below 40 Hz?
How to plot the smoothed curves more 'graceful'
How to plot spectrum in octave or one-third-octave bands?
How to validate numbers typed in the Plot Toolbar?
How to limit the plotting range, e.g. plotting only in the range 100-5000 Hz?
Contents
Index
Search
Previous
Next
